Vacupor® MS

Vacupor MS

Vacupor® MS is the standard design of our vacuum insulation panel with double middle seam.
Through the use of different barrier foils, Vacupor® MS can be adapted individually to the requirements of different applications, regarding life span, robustness and cost.

Vacupor® MS is characterized by a very good surface quality, lack of sealing flaps on the long sides, tight dimensional tolerances and high format flexibility. Various geometries (curved, cut-out etc.) are possible. Available with and without taped bottom and sealing flap. Especially suitable for medium and large production batches.

Vacupor MS Schnittbild

Please notice:
Vacupor® MS is not approved by the German building and construction authorites for building applications. Vacupor® MS may just be applied in areas where a Vacuum Insulation Panel is treated as an unregulated construction product, if an admission on a single case exists or will be obtained.

The procured technical approval no. Z-23.11-1662 applies only to the products referred to therein. Only these products meet the increased requirements for fire protection that are required to obtain an authorization. This is achieved by a modified barrier film.

The thermal conductivity value just describes the value of the Vacuum Insulation Panel under the mentioned conditions, measured in the center of the panel.

The measured value does explicitly not correspond with the rated value, determined by the DIBt and may not be used in Germany for the implementation of thermal calculations for buildings.

 

Downloads

Data sheet

Safety

Product- and handling instructions